Frigidaire IM116000 Instrukcja Właściciela Pobierz pdf

ICE MAKER

INSTALLATION

INSTRUCTIONS

P/N 240394901

The following items will be required to install the ice maker kit.

• 1/4 inch copper supply line with shut off valve

• 1/4 inch brass compression nut and ferrule

• Freezer shelf (Some models not eqipped with shelf). If your

model does not have one, contact your dealer to order one.

The copper tubing and shut off valve are available in a kit from your

local hardware or plumbing supply store. Coil enough tubing at the

back of the unit to allow movement for cleaning.

To Avoid Property Damage:

• Copper tubing is recommended for the water supply line. Water supply tubing made of 1/4”

plastic is not recommended since it greatly increases the potential for water leaks.

The manufacturer will not be responsible for any damage if plastic tubing is used for the

supply line.

• DO NOT install water supply tubing in areas where temperatures fall below freezing.

• Connect the ice maker to a drinkable water source that is not tied into a water softening

system. Chemicals from the softener may damage the ice maker, causing it to

malfunction.

To avoid electric shock, which can cause death or severe personal injury,

disconnect the refrigerator from electrical power before connecting a water supply line to

the refrigerator.

1 2 3 4 5 6 7

Podsumowanie treści

Strona 1 - INSTRUCTIONS

ICE MAKERINSTALLATIONINSTRUCTIONSP/N 240394901The following items will be required to install the ice maker kit.• 1/4 inch copper supply line with shu

Strona 2 -  Putty Knife  Pliers

2Tools Required: Putty Knife  Pliers ¼ inch Socket Wrench  Needle Nose Pliersor Nut Driver  Adjustable Wrench Knife1. Ice Maker2. Ice Container3

Strona 3

31. Unplug refrigerator from wall outlet.2. Remove ice tray rack from freezer (some models).3. Remove freezer shelf (some models) by pushing shelfto l

Strona 4

410. Install adjustable leveling bracket (7) on bottom ofice maker with screw (6). DO NOT tighten bracket.(Bracket will be tightened later.)11. Star

Strona 5

516. Locate factory punched holes at bottom right cornerof rear panel. Holes are only drilled through cabinetliner. Align water valve bracket with fac

Strona 6

6 IMPORTANT: Ensure that your water supply line connections comply with all local plumbing codes.Before Installing The Water Supply Line, You Will Ne

Strona 7 - Automatic Ice Maker Tips

7Automatic Ice Maker TipsRemember that water quality determines your ice quality. Do not connectthe ice maker to water that is softened. Chemicals fro