Frigidaire FFRS1022R1 Schemat Okablowania Pobierz pdf

READ BEFORE INSTALLING UNIT

For Slider Casement Air Conditioners

Installation Instructions

NOTE:

These instructions describe installation in a typical wood framed window with a wood SLIDE-BY sash, or

installation in a metal CASEMENT window. Modification may be necessary when installing in windows made

differently than those shown in these instructions.

WARNING:

Electrical ground is required on this appliance.

Electrical Shock and Personal Injury Hazard

DO NOT ground to a gas line.

If cold water pipe is interrupted by plastic, non-metallic gaskets, or other insulating materials, DO NOT use for

grounding.

Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded.

DO NOT modify power supply cord plug. If it does not fit outlet, have a proper outlet installed by a qualified

electrician.

DO NOT have a fuse in the neutral or grounding circuit. A fuse in the neutral, or grounding circuit could result in

an electrical shock.

DO NOT use an extension cord with this appliance.

Failure to follow these instructions could result in electrical shock, serious injury, or death.

Meeting Electrical Requirements

OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES. DO NOT, UNDER ANY CIRCUMSTANCES,

REMOVE THE POWER SUPPLY CORD GROUNDING PRONG.

NOTE:

If codes permit, and a separate grounding wire is used, it is recommended that a qualified electrician determine

that the grounding path is adequate and not interrupted by plastic, non-metallic gaskets, or other insulating

materials.

2020213A1659

Pay attention to danger and safety notices.

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may

be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install

the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To

prevent injury or strain, use proper lifting and carrying techniques when moving unit.

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended

period of time.

Handle air conditioner with care.

Make sure air conditioner does not fall during installation.

Carefully read the installation manual before beginning.

Follow each step as shown.

Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.

INSTALLATION WARNINGS AND CAUTION

1 2 3 4 5 6 7 8

Podsumowanie treści

Strona 1 - Installation Instructions

READ BEFORE INSTALLING UNITFor Slider Casement Air Conditioners1Installation InstructionsNOTE:These instructions describe installation in a typical wo

Strona 2

2Installation InstructionsReceptacle Wiring:Receptacle wiring should be a minimum of 14 gauge. Use copper wire only. It is your responsibility to prov

Strona 3

3Installation InstructionsMake sure you have all the necessary parts.Installation kit contents (FIG.3):HardwareSide channel sealSupport bracePlatformA

Strona 4

Inside wallof houseSiding-protectionboardApply track sealto window sideof track.FIG.9FIG.8Awith platform tab pressedagainst window track Center

Strona 5 - Outside edge is 3/16”

5Installation Instructions To remove front as shown (FIG.16)1. Remove the two front retaining screws from the front frame.2. Press firmly on e

Strona 6

FIG.186Installation Instructions Slide inner window sash firmly against side of the cabinet. Make sure not to peel the seal strips from the wind

Strona 7

7Installation InstructionsNOTE:If you are planning to use a siding-protection board (see Step 29) on the outside of your house, hold the board inplace

Strona 8

8Installation Instructions Cut side channel seal into 2 equal lengths. Remove the protective backing and apply it to the rear side of thecabinet